Abrégé

A flange connector assembly for connecting trim pieces of a vehicle. A first male portion having an end portion connected to a first trim part and a second female portion connected to a trim part end to be attached to the first trim part. The first male portion has a connection portion with a T-shaped cross section and the second portion has a second connecting portion with a T-shaped cavity. The first male connecting portion and the second female connecting portion fit to precisely engage each other and retain the trim portion to be attached. The protruding T-shaped portion includes raised tuning flanges and is capable of adjusting up/down, inboard/outboard or twist fine tuning for providing alignment adjustment to the trim pieces via adjustment of the flange heights in the mold and providing new precisely adjusted T-flanges for providing a tuned butt connection of a trim strip for instance.

Classes IPC  ?

• B29C 45/00 - Moulage par injection, c. à d. en forçant un volume déterminé de matière à mouler par une buse d'injection dans un moule fermé; Appareils à cet effet
• B60R 13/02 - Moulures décoratives; Gouttières; Garnitures des parois; Pavillons ou garnitures des toits
• F16B 5/00 - Jonction de feuilles ou de plaques soit entre elles soit à des bandes ou barres parallèles à elles

Abrégé

A fixture for holding a workpiece includes clamps cofigured to engage tie rods secured to the workpiece, locating pins configured to engage a corresponding pin secured to the workpiece, pads, and actuators configured to move clamps for alternately drawing the workpiece into contact with the pads and disengaging the tie rod from the clamp such that the fixture assembly can release the workpiece.

Classes IPC  ?

• B23Q 3/06 - Moyens de fixation de la pièce